How To Set Up Acetylene Torch

How to Set Up an Oxy-Acetylene Torch

by G.K. Lowell

Photos and graphics past KKLowell

Steampunk types might romanticize the artful today, merely a world rendered apart by huge saws and held together by rivets and bolts was never going to reach its full potential. No mechanical connection could e'er be every bit reliable as a connection fused together at the molecular level, and automobile-based cutting methods had already reached their limits by the 20th century. Then, the earth had to motility past mass associates with rivets and bolts, and into an era where the pure, awesome power of fire and molten metal reigned supreme.

Step 1

Secure the oxygen and acetylene tanks in the torch cart. This step is an of import one for the safety of you and others in the vicinity, then don't skip it. If you don't have a cart nonetheless, secure the tanks to an upright beam or some other vertical solid object using appropriate tie-down straps.

Stride 2

Remove the covers protecting the tank valves and attach the regulators to the valves. Screw the fittings into the valves as far as you lot can past manus then tighten securely with a wrench.

Step 3

Attach the hoses to the regulators. Connect the green hose to the oxygen regulator and the reddish hose to the acetylene regulator.

Footstep 4

Connect the other end of the hoses to the torch handle. Push the cutting torch in to the torch handle and hand-tighten the nut. Close the valves on the torch handle and the cutting torch.

Footstep five

Turn the valve on the oxygen tank completely open. The valve has a seal on the shaft that works when the valve is fully open up and helps prevent oxygen loss when the torch is in operation.

Pace half dozen

Turn the adjusting screw on the oxygen regulator clockwise until the small gauge on the regulator registers somewhere in the 40 to 60 psi range.

Footstep vii

Turn the valve on the acetylene tank counterclockwise a quarter plough to open up. Arrange the acetylene regulator until the modest gauge on the regulator registers 10 psi. Open the oxygen valve on the torch handle completely by turning counterclockwise until it stops.

Pace 8

Slightly open the oxygen valve on the cut torch. Open but plenty to get-go the flow of oxygen through the torch. Open the acetylene valve on the torch handle nearly 1/eight turn, or 45 degrees.

Light the torch with a spark lighter and adjust the acetylene valve on the torch handle and the oxygen valve on the cutting torch until the flame has no yellow areas and the heart is bright blue and well divers. Cheque the regulator gauges and adjust as necessary to maintain the proper pressures.

Things You'll Need

• Oxygen-acetylene torch set
• Torch cart
• Oxygen tank
• Acetylene tank
• Wrench set
• Spark lighter

Warnings

• Always disconnect the regulators from the tanks and put the valve covers on before taking the tanks from the torch cart or when transporting in a vehicle.
• Always use torches with the tanks in the upright position only.

Writer Bio

M.K. Lowell is a freelance writer who has been writing professionally since June 2008, with manufactures actualization on various websites. A mechanic and truck driver for more than 40 years, Lowell is able to write knowledgeably on many automotive and mechanical subjects. He is currently pursuing a degree in English language.

More Manufactures

Source: https://itstillruns.com/set-up-oxyacetylene-torch-4909709.html

Share this post